Model Desk Renovation & Tamiya GT-R

Since the last post, I've done a few things to make my workspace a bit better.

Pasted Graphic 82

First I built myself a little shelf, so that I could have better access to my various paints, glues and other toxic chemicals.  I just picked up a small sheet of thin plywood at Home Depot as well as some little 1"x1"x12" blocks of pine.  I worked up some quick plans, drew them out onto the plywood, busted out the jigsaw and started cutting.  After some gluing, drilling, a few wood screws, and a couple coats of gray spray paint, I now have a nice little shelf for my desk (you can also see here the monitor for the cam/computer setup I mentioned in the previous post):

Pasted Graphic 83

Next, after knocking over my bottle of high-power plastic cement, and melting all the lines off the middle of my cutting mat, I thought it might be a good idea to make sure that doesn't happen again.  Especially since this was not the first time I had knocked this same bottle over.  After rummaging around a bit, I found some nice wood I had left over from the base I made for the Panzer project (red oak, I think).  I cut a couple squares of this, glued them together, and then, using a hole saw, drilled a hole just a bit bigger than the glue bottle.  A couple coats of polyurethane, and now I've got a little block that keeps my glue bottle from falling over and doesn't look too terrible.

Pasted Graphic 84

Before I jumped into another long-term wooden project, I decided to make one more plastic kit.  I settled on the Tamiya Calsonic Impul GT-R kit that I bought a while back, thinking it would be fairly quick and easy, since it doesn't have an engine and only a rudimentary interior.  I had intended to build it straight from the box, but I couldn't resist adding an third party racing harness kit.  Here you can see the completed interior, as well as the mostly-built exterior shell:

Pasted Graphic 85

Pasted Graphic 86

Pasted Graphic 87

I should wrap this project up in the next few weeks, and then I'll get some proper photographs of both this completed model and the motorcycle model that I finished before this one.  Stay tuned!


Comments